ماژول محافظ شارژ باتری لیتیومی 3 سل 10A

3S 10A 12V 18650 Lithium Battery Charger Board Protection Module
In 3S 10A 12V 18650 Lithium Battery Charger Board Protection Module, 3S stands for 3 18650 batteries or polymer lithium battery series combination.
With 10.8V rated voltage for polymer battery, 11.1V 18650 or 3.7V lithium battery rated voltage and 12.6V lithium battery can be charged.
And discharge 10A (referring to the maximum discharge current limit) Lithium battery protection board it also Comes with over-charge, over-discharge, over-current, short circuit protection
formula expansion
1C battery expansion, 2000 capacity is equal to 2AH * 1 = 2A upper limit of current.
3C battery expansion, 2000 capacity equal to 2AH * 3 = 6A upper operating current.
If the battery get heat, does not apply that battery, such situation cannot be long-term use, the battery will soon be
damaged.
1. Size: 50 x 15 mm
2. Charging Voltage: 12.6 V-13 V
Notes
1: Once you have charged the first line, it will have output.
2: When connecting three battery groups, please make sure that the voltage of each battery group, if not the same, fill each battery separately and then use it in series. discharge test, the fastest battery voltage drop, which group is low battery.(2 good battery + a use effect = 3 low battery low battery use effect).
Warning
The protection board can not be used for lithium iron phosphate batteries, lamp hernia, hand drill battery, electric battery fish, electric bicycle battery, car battery for children, 775 (4A) motor, 1 W fish eye LED light, please pay attention customer purchase connection! Described in terms of power for the following products: Massager rechargeable battery, LED ready light power supply, 12 V electronic products, solar street lamp battery, power backup monitor, and other products.

Datasheet: 3S-8A

Precautions
1. Pay attention to the input and output voltage and load current, do not use more than the power of the module and cause it to burn.
2. This module has an anti-static protection circuit, please do not touch it with your hands when working on the module to avoid damaging it.