ماژول شتاب سنج MPU6050

GY-521 / MPU-6050 Module
The Three Axis Acceleration + Gyro Breakout (MPU-6050) is a great motion processing module.
By combining a MEMS 3-axis gyroscope and a 3-axis accelerometer on the same silicon die together with an onboard Digital Motion Processor™ (DMP™) capable of processing complex 9-axis MotionFusion algorithms, the MPU-6050 does away with the cross-axis alignment problems that can creep up on discrete parts.
It is very accurate, as it contains 16-bits analog to digital conversion hardware for each channel.
Therefor it captures the x, y, and z channel at the same time. The sensor uses the I2C-bus to interface with the Arduino.
The breakout board for the MPU-6050 makes this tiny QFN package easy to work into your project.
Every pin you need to get up and running is brought out, including the auxiliary master I2C bus which allows the MPU-6050 to access external magnetometers and other sensors.
The onboard LDO chip enable you to interface the board with 5V & 3V3 MCUs without the need of level shifters.
Features
On-board MPU – 6050 integrated 6 axis motion processing chip
On-board LDO chip, support 5 V / 3.3 V voltage input
Commonly used pin have been bropught out with a standard 2.54mm spacing
Module support IIC standard communication protocol
Users can control program of the accelerator full grid sensor in the range of ±2g, ±4g, ±8g and ±16g
Angular velocity full case sensing range for ±250, ±500, ±1000, and ±2000dps
Digital Motion Processing™ (DMP™) engine offloads complex MotionFusion, sensor timing synchronization and gesture detection
Embedded algorithms for run-time bias and compass calibration. No user intervention required
On-chip ADC & temperature sensor to measure the MPU-60X0 die temperature
Package includes
1 x Three Axis Acceleration + Gyro Breakout (MPU-6050)
1 x Header Straight
1 x Header Right Angle