ماژول جی پی اس NEO6MV2 GPS MODULE

Description
NEO 6M GPS Module With EEPROM For Arduino And Flight Controllers [GY-NEO6MV2] is a GPS module with ceramic edge antenna, to diagnose GPS data for various flight control that provide GPS computer test software such as MWC/AeroQuad.
This GPS configuration data is not disappeared any time, because this data is saved on the internal EEPROM with a backup battery in power off situation.
This GPS module has high quality and ability against low price and size.
This module can communicate with the Arduino, Raspberry Pi, MSP430, and MSP432 through the UART interface.
Work guides
Power on, the module will automatically acquire satellite signals and a fix position.
Once it has a fix position, the module will blink the onboard LED.
This LED will continue to blink while the module has a fix position.
Features
Model: GY-GPS6MV2.
With ceramic antenna.
With the LED signal indicator lamp.
EEPROM power-down save configuration parameter data
Power supply: 3-5V.
The default baud rate: 9600.
Compatible with different flight controller module.
Module Size : 2.5cm x 3.5cm.
Antenna Size : 2.5cm x 2.5cm x 0.8cm.
Note: When buying, consider the possibility of non-registration and disruption to operators.

NEO-6M GPS Module Pinout
GND is the ground pin and needs to be connected to the GND pin on the Arduino.
TxD (Transmitter) pin is used for serial communication.
RxD (Receiver) pin is used for serial communication.
VCC supplies power to the module.You can connect it directly to the 5V pin on the Arduino.

GPS NEO6MV2 how to use?
To use your NEO6MV2 GPS you must use a development board such as, for example, you can use Arduino boards, ESP8266 or any other microcontroller that has a serial port, to obtain readings from the module you can use the libraries available for each environment.